|
|
SHUTTER MOUNTING INSTRUCTIONS
On Masonry, Brick, Cinderblock, etc.
1. Place shutter in
desired position. Mark locations for 6 holes
approx 1.5" (38mm) from top and bottom and in
line at the centre.
2. Lay shutter face
up and drill a 3/8th" (9.5mm) hole through
the rail at each mark.
Re-position shutter in the desired position and
using a punch or other suitable marker, mark
the mounting hole location on the building.
3. Remove shutter
and at the marks drill a 9/32"(7mm) diameter
hole into the wall at least 1 3/4"(45mm) deep.
Place shutter back in the desired position. Put
shutter lok in hole. Using a hammer gently
tap the spike in part way. Repeat until all 6
spikes are started then finish tapping them all
in.
4. BE CAREFUL NOT
TO TAP THEM IN TOO FAR
They should only go in far enough for the underside
of the shutterLok head to touch the shutter
when the back edge of the shutter is touching
the building.
Shutters can be easily cleaned with mild dish
soap and water to maintain their lustre. |
THREE WAYS TO INSTALL DENTIL EXTERIORS:
STARTING WITH AN INSIDE OR OUTSIDE CORNER
EXTERIOR
DOOR SURROUND INSTALLATION
DOOR AND GARAGE SURROUND ILLUSTRATIONS
 
|
|
